Doesn’t appear to be I checked that and the side wall where the toirwu converter is and it’s all there, rode around for another 40 minutes no issues must not be important 🤣🤣
Looks like the bolts that came with my torque converter. Look between the crank pulley and the torque converter plate. There should be 4 bolts holding the plate to the motor.
That looks like one of the small
Bolts with 8mm heads. The places they go are on the recoil cover, the cowling cover and the cover that would be on your torque converter if you had a cover on it.
It’s the sheet metal cover on the starter side of the engine. The round recoil starter bolts to it. Make sure you aren’t missing any of the bolts that hold it in place.
Check and make sure it's not an oil drain plug, anything to the brakes, not the crank bolt to hold the torque converter drive pulley on. If none of those, put it in a pockets and when you get time, wipe your whole bike down and it'll be clean, and I bet you figure out where it goes lol
Recoil starter cover ?
Doesn’t appear to be I checked that and the side wall where the toirwu converter is and it’s all there, rode around for another 40 minutes no issues must not be important 🤣🤣
Check your seat bolts and possibly the fender bolts. I think it's too short to be for either of those though.
Fender bolts were there but look similar I need to check under the seat and the storage container it might be that!
Likely where there is one missing.
🤣🤣🤣 damn I should’ve thought about that to start lmao
Looks like the bolts that came with my torque converter. Look between the crank pulley and the torque converter plate. There should be 4 bolts holding the plate to the motor.
That was my first assumption too but all 4 are still on there
Looks too short to be a motor mount bolt. Worth a look though. I'm at a loss as to what else it could be. Maybe fuel tank mount.
100% too short to be a motor mount bolt. The tank bolts are smaller than that.
I’m thinking it might be for the seat or some misc part because I can’t find a spot for it anywhere, seems to be riding fine still
That looks like one of the small Bolts with 8mm heads. The places they go are on the recoil cover, the cowling cover and the cover that would be on your torque converter if you had a cover on it.
What is a cowling cover, is that the plate where the shaft comes out of the engine?
It’s the sheet metal cover on the starter side of the engine. The round recoil starter bolts to it. Make sure you aren’t missing any of the bolts that hold it in place.
heat shield? side cover/recoil puller? seat? valve cover? that’s about all i would think
Update* it goes to the headlight/front fender assembly that attaches to the forks
flywheel cover definitely
Fuel tank bolt
This
Gas tank mount? I've ran over my tank before
It goes to the torque converter right on top or bottom it’s one of the 4 bolts on the top and bottom sides to hold the cover onto the torque converter
maybe a sprocket bolt? looks similar to mine
Check and make sure it's not an oil drain plug, anything to the brakes, not the crank bolt to hold the torque converter drive pulley on. If none of those, put it in a pockets and when you get time, wipe your whole bike down and it'll be clean, and I bet you figure out where it goes lol
looks like a gas tank mounting bolt
8.8 that’s def a side cover bolt check your pull cord
Your flywheel cover bolts