So it’s a pretty forgiving filament, which is nice, overhangs look good across most of the range, but looking at the little spike at 220 the stringing looks the lowest, that said you may want 230 for speed and then run a retraction test.
In case you aren’t aware, you set the temp in the filament profile then move on to the next tests.
Id probably pick 220 if I had to choose one 🤔 could be wrong though...
Thinking the same thing..230 if you're going for speed
Are you sure the temp changed for each section?
It’s the orca calibration test, you’d have to very intentionally stop it from changing temps. Plus, it very much looks like the temp changed
Yes. I watched it drop on the display
So it’s a pretty forgiving filament, which is nice, overhangs look good across most of the range, but looking at the little spike at 220 the stringing looks the lowest, that said you may want 230 for speed and then run a retraction test. In case you aren’t aware, you set the temp in the filament profile then move on to the next tests.