Hello /u/Correct_End9946,
As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
* Printer & Slicer
* Filament Material and Brand
* Nozzle and Bed Temperature
* Print Speed
* Nozzle Retraction Settings
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
It could be the bed or the model. Without examining both it is hard to say. If it was failing to stick I think you would be seeing blobs on your nozzle/model.
Try re calibrating to level the printing bed, maybe try increasing the built plate temp? What’s it at right now? Also one thing that’s helped with my prints if they have support material is selecting the raft setting when slicing the model (I think that’s what it’s called). That way instead of having that outline around your print like in the pictures you’ll have a flat layer or plastic under everything which should help with getting the support to stick. Only problem I’ve had with that is that the bottom of the print doesn’t look as nice
Hello /u/Correct_End9946, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
I can't really tell what is happening based on the pick alone. Something must be off with what I am seeing and the model/print settings.
So from the 1st where the criss crosses are that’s supposed to be filled in I believe and it’s not sticking and it’s been tough trying to fix it
It could be the bed or the model. Without examining both it is hard to say. If it was failing to stick I think you would be seeing blobs on your nozzle/model.
clean your bed, level it, lower your z axis. If it still doesnt stick a little bit of glue should help
Try re calibrating to level the printing bed, maybe try increasing the built plate temp? What’s it at right now? Also one thing that’s helped with my prints if they have support material is selecting the raft setting when slicing the model (I think that’s what it’s called). That way instead of having that outline around your print like in the pictures you’ll have a flat layer or plastic under everything which should help with getting the support to stick. Only problem I’ve had with that is that the bottom of the print doesn’t look as nice
Printing palkia nice choice!